ANY REPAIR!

Oil Change Cleveland

Book an appointment at www.thelandautorepair.com or call 855-253-2886

Performing an oil change is one of the most straightforward and essential maintenance tasks for a vehicle. Here’s a step-by-step guide on how to do it:

  1. Gather Supplies: You’ll need fresh engine oil, a new oil filter, a wrench or socket set, an oil drain pan, gloves, safety glasses, and a funnel.
  2. Prepare the Vehicle: Park the vehicle on a level surface and engage the parking brake. If necessary, lift the front of the vehicle using ramps or a jack and jack stands. Ensure the vehicle is securely supported before crawling underneath.
  3. Locate the Oil Drain Plug: The oil drain plug is typically located on the bottom of the engine’s oil pan. Refer to your vehicle’s owner’s manual for its exact location.
  4. Drain the Oil: Place the oil drain pan beneath the oil drain plug. Loosen the drain plug using a wrench or socket set, being careful not to burn yourself as the oil may be hot. Once loosened, remove the drain plug completely and allow the old oil to drain into the pan fully.
  5. Replace the Oil Filter: Locate the oil filter, which is usually near the oil pan. Using an oil filter wrench, loosen and remove the old oil filter. Before installing the new filter, lubricate the rubber gasket on the filter with a bit of fresh oil. Then, screw the new filter onto the engine by hand until it’s snug, then give it another quarter to half turn.
  6. Add New Oil: Locate the oil filler cap on the top of the engine. Remove it and place a funnel into the filler hole. Pour in the recommended amount of fresh oil, as specified in your vehicle’s owner’s manual. Once filled, replace the oil filler cap securely.
  7. Check Oil Level: Start the engine and let it run for a minute or two to allow the new oil to circulate. Then, turn off the engine and wait a few minutes for the oil to settle back into the oil pan. Check the oil level using the dipstick, and add more oil if necessary to bring it to the proper level.
  8. Dispose of Old Oil: Transfer the old oil from the drain pan into a suitable container for recycling. Many auto parts stores or service stations accept used oil for recycling.
  9. Inspect for Leaks: Before driving the vehicle, inspect around the oil drain plug and oil filter for any signs of leaks. Tighten as necessary.
  10. Record Maintenance: Lastly, be sure to record the date and mileage of the oil change in your vehicle’s maintenance log. This helps you keep track of when the next oil change is due.

Following these steps will help ensure that your vehicle’s engine remains properly lubricated and protected, promoting longevity and optimal performance.

Book an appointment at www.thelandautorepair.com or call 855-253-2886

oil change Cleveland, oil change cost cleveland

Leave a Comment

Your email address will not be published. Required fields are marked *